MQSeries.net :: View topic - SSL problem between AIX and z/OS(resolved)

zlf · Posted: Tue Sep 19, 2006 1:07 am Post subject:

Hi all,
I have built a pair of sender and receiver channel between AIX(sender) and z/OS(receiver) without SSL first. The channel runs after "start channel".

However, assigning SSLCIPH to channels will make them do not work. "start channel(AIX.TO.ZOS)" will produce the log on AIX at the bottom of the thread. No corresponding log found on z/OS using SD/System log.

I think my configuration is correct since I have used the same way to configure two qm mangers(both on AIX) communicating will ssl. And it works well. But I really cannot find where is the problem

.

----- amqrmrsa.c : 461 --------------------------------------------------------
09/19/06 15:53:04
AMQ9002: Channel 'AIX.TO.ZOS' is starting.

EXPLANATION:
Channel 'AIX.TO.ZOS' is starting.
ACTION:
None.
-------------------------------------------------------------------------------
09/19/06 15:53:06
AMQ9665: SSL connection closed by remote end of channel 'AIX.TO.ZOS'.

EXPLANATION:
The SSL connection was closed by the remote end of the channel during the SSL
handshake. The channel is 'AIX.TO.ZOS'; in some cases its name cannot
be determined and so is shown as '????'. The channel did not start.
ACTION:
Check the remote end of the channel for SSL-related errors. Fix them and
restart the channel.
----- amqccisx.c : 1013 -------------------------------------------------------
09/19/06 15:53:06
AMQ9999: Channel program ended abnormally.

EXPLANATION:
Channel program 'AIX.TO.ZOS' ended abnormally.
ACTION:
Look at previous error messages for channel program 'AIX.TO.ZOS' in
the error files to determine the cause of the failure.
----- amqrccca.c : 883 --------------------------------------------------------