| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| MB/JDBC adapter, InterchangeSystem.cfg not found in path.... |
« View previous topic :: View next topic » |
| Author |
Message
|
| dcapodic |
 Posted: Fri Jul 28, 2006 9:06 am Post subject: MB/JDBC adapter, InterchangeSystem.cfg not found in path.... |
 |
|
Apprentice
Joined: 03 Sep 2003
Posts: 32
|
Hi....
As promised in a previous post, more questions as I progress with this  I am trying to configure the JDBC Adapter to work with WBIMB. I installed the framework, and fixpack, 2.6.0.5 and the JDBC Adapter and fixpack, 2.6.5 without issue. The framework "Connector configurator" starts up and seems to work without issue. Hoever, I cannot start the JDBC Connector and receive the following error, "InterchangeSystem.cfg not found in path". Checking the install docs, it always refers to WID and ICS so I know what the error means but since I am not using ICS not sure how to get around this requirement. I have seen some posts where people are using MB instead of ICS so I am sure it can be done, just not sure how
TIA....
Dan |
|
| Back to top |
|
 |
| MB12345 |
| Posted: Fri Jul 28, 2006 10:44 am Post subject: |
|
|
Newbie
Joined: 28 Jul 2006
Posts: 6
|
Hi..
Change Connector properties like this:-
C:\IBM\WebSphereAdapters\connectors\JDBC\start_JDBC.bat JDBC WMQI_WAS -cC:\JDBCConnector.cfg
SSS |
|
| Back to top |
|
|
| dcapodic |
| Posted: Fri Jul 28, 2006 11:06 am Post subject: |
|
|
Apprentice
Joined: 03 Sep 2003
Posts: 32
|
Hi....
Then, is JDBCConnector.cfg the config file that you produce when you configure the framework connector?
Thanks....
Dan |
|
| Back to top |
|
|
| MB12345 |
| Posted: Fri Jul 28, 2006 12:11 pm Post subject: |
|
|
Newbie
Joined: 28 Jul 2006
Posts: 6
|
Hi,
Create a Connector using SystemManager and save[with extention .cfg]
When u install JDBCConnector it creates a connector like
start -> programs -> .....->connectors->JDBCConnector
Open that connector properties and set target path in the shortcut tab.
C:\IBM\WebSphereAdapters\connectors\JDBC\start_JDBC.bat JDBC WMQI_WAS -cC:\JDBCConnector.cfg
NOTE: First path is your start_JDBC.bat file path and second path is ur .cfg file path.
SSSS |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
