| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| On AIX 5.3, running a QMGR with a non-mqm ID |
« View previous topic :: View next topic » |
| Author |
Message
|
| JosephGramig |
 Posted: Tue Jun 13, 2006 5:40 pm Post subject: On AIX 5.3, running a QMGR with a non-mqm ID |
 |
|
Grand Master
Joined: 09 Feb 2006
Posts: 1244
Location: Gold Coast of Florida, USA
|
If I start a QMGR with an ID that is in the mqm group but isn't mqm, the processes run as that ID.
This was not the case on Solaris. Whatever ID was used to start the QMGR, you would see mqm as the process ID.
Is this a bad thing? Or normal for AIX? So far, I see no ill effects.
I use the scripts for HACMP and they also start the QMGR with the broker service ID. The same thing happens on the non-HACMP LPARs.
I am using WMQ 6.0.0.1 on AIX 5.3 ML4.
_________________
Joseph
Administrator - IBM WebSphere MQ (WMQ) V6.0, IBM WebSphere Message Broker (WMB) V6.1 & V6.0
Solution Designer - WMQ V6.0
Solution Developer - WMB V6.1 & V6.0, WMQ V5.3 |
|
| Back to top |
|
 |
| jefflowrey |
| Posted: Tue Jun 13, 2006 6:17 pm Post subject: |
|
|
Grand Poobah
Joined: 16 Oct 2002
Posts: 19981
|
Using su or sudo in your broker script is not too hard either, to ensure that mqm starts the processes...
I don't know of any particular problems, but I can think of some places where there might be problems - ownership of shared memory segments for example, files, or etc.
_________________
I am *not* the model of the modern major general. |
|
| Back to top |
|
|
| markt |
| Posted: Wed Jun 14, 2006 4:27 am Post subject: |
|
|
Knight
Joined: 14 May 2002
Posts: 508
|
| Some "ps" commands show effective ids, some show real ids. |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
