MQSeries.net :: View topic - Using supportpac MA0W to trace API calls

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » General IBM MQ Support » Using supportpac MA0W to trace API calls

Using supportpac MA0W to trace API calls

« View previous topic :: View next topic »

Author

Message

hilltops

Posted: Thu May 04, 2006 7:30 am Post subject: Using supportpac MA0W to trace API calls

Centurion

Joined: 01 Mar 2006
Posts: 112

I have attached the supportpac MA0W to a queue manager to trace API call. Seems to work fine, but my question is - "Is it a requirement for the queue manager to be stop and restarted for the tracing to take effect?"

Thankx

jefflowrey

Posted: Thu May 04, 2006 8:30 am Post subject:

Grand Poobah

Joined: 16 Oct 2002
Posts: 19981

Maybe you should read what the Info Center says on "tracing".

It seems fair that, since the documenters went to the trouble to write an entire section on this topic, then you should go to the trouble to read it.
_________________
I am *not* the model of the modern major general.

hilltops

Posted: Fri May 05, 2006 12:49 am Post subject:

Centurion

Joined: 01 Mar 2006
Posts: 112

Thankx for reminding me that I could find this out by reading the documentation on "tracing", as if I would not have already done that. Bless those writers of documentation

Basically, I am not trying use standard tracing, but API exits to monitor a message flow without having to interrupt other important message flows thru the queue manager.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » General IBM MQ Support » Using supportpac MA0W to trace API calls

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP