| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Setup MQ Triggering |
« View previous topic :: View next topic » |
| Author |
Message
|
| tomz |
 Posted: Fri Apr 07, 2006 6:12 am Post subject: Setup MQ Triggering |
 |
|
Newbie
Joined: 07 Apr 2006
Posts: 1
Location: West Chester
|
Hello all, I am trying to setup MQ triggering for Websphere MQ V.6 on Server 2003.
If I put a message to a queue with a Process Definition and Initiation Queue,
It does not put a message to the designated Initiation Queue(SYSTEM.DEFAULT.INITIATION.QUEUE)
I have setup the service to runmqtrm, I have verified it is running in Task Manager.
It is my understanding that the initiation queue put should be before the runmqtrm process anyway.
Can anyone offer suggestions where I could start?
Thanks
Tomz. |
|
| Back to top |
|
 |
| sandiksk |
| Posted: Fri Apr 07, 2006 6:16 am Post subject: |
|
|
Centurion
Joined: 08 Jun 2005
Posts: 133
|
| did you make sure you turned on triggering on the queue and you specified the name of the initiation queue corectly. what did you set the trigger type to. |
|
| Back to top |
|
|
| jefflowrey |
| Posted: Fri Apr 07, 2006 6:16 am Post subject: |
|
|
Grand Poobah
Joined: 16 Oct 2002
Posts: 19981
|
http://www.mqseries.net/phpBB2/viewtopic.php?t=25092
You can't tell if a message is put or not if the trigger monitor is running, because it will consume the message almost immediately.
Conversely, if the INITQ is not open for input (i.e., the trigger monitor is not running), then MQ will not put a trigger message on the queue.
So you can't tell anything about what's going on by trying to look for a trigger message on the INITQ.
_________________
I am *not* the model of the modern major general. |
|
| Back to top |
|
|
| fjb_saper |
| Posted: Fri Apr 07, 2006 11:02 am Post subject: |
|
|
Grand High Poobah
Joined: 18 Nov 2003
Posts: 20756
Location: LI,NY
|
| Quote: |
| I have setup the service to runmqtrm, I have verified it is running in Task Manager. |
Stop the service and run the trigger monitor manually from a DOS window. There is a lot of output that is very helpful for error resolution that will be generated this way that you won't have access to if you run the trigger monitor as a service.
Enjoy 
_________________
MQ & Broker admin |
|
| Back to top |
|
|
| oz1ccg |
| Posted: Fri Apr 07, 2006 12:56 pm Post subject: |
|
|
Yatiri
Joined: 10 Feb 2002
Posts: 628
Location: Denmark
|
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
