MQSeries.net :: View topic - WMB6 stupid question re. ESQL breakpoint

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » WMB6 stupid question re. ESQL breakpoint

WMB6 stupid question re. ESQL breakpoint

« View previous topic :: View next topic »

Author

Message

markneil

Posted: Fri Mar 31, 2006 6:26 am Post subject: WMB6 stupid question re. ESQL breakpoint

Apprentice

Joined: 09 Sep 2003
Posts: 26

Hi,
The V6 debugger is great. It works (!), I can set breakpoints in the flow, step into/through the ESQL no problem. But when I set a breakpoint in the ESQL iself, how do I tell the debugger to proceed directly to that breakpoint? All I can seem to do is step through the code line by line, or 'proceed' which skips the ESQL breakpoint. Help...!

Cheers
mark

fjb_saper

Posted: Fri Mar 31, 2006 3:05 pm Post subject:

Grand High Poobah

Joined: 18 Nov 2003
Posts: 20756
Location: LI,NY

At the left of the debug palette there is a green button. This should get you to the next breakpoint. If you use the similar button at the right you instruct the debugger to "run the message to completion".

Enjoy

PS you might want to make sure you are at FixPack1 + Ifix001 + Ifix002 on the Toolkit.

_________________
MQ & Broker admin

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » WMB6 stupid question re. ESQL breakpoint

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP