MQSeries.net :: View topic - MQ 5.3 on multinode MS Cluste with Windows 2003

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » MQ 5.3 on multinode MS Cluste with Windows 2003

MQ 5.3 on multinode MS Cluste with Windows 2003

« View previous topic :: View next topic »

Author

Message

andrewc

Posted: Tue Jan 24, 2006 4:05 am Post subject: MQ 5.3 on multinode MS Cluste with Windows 2003

Newbie

Joined: 24 Jan 2006
Posts: 1

Hi
I would like to install MQ 5.3 on a 4 node Windows 2003 cluster. The documentation seems to refer in general to a 2 node cluster configuration.
Has anyone done this?
Is it a supported configuration ?
Would there be any additional steps in the installation?

I already have a number of 2 node clusters that all installed and work well. Just not so sure if the same process would apply to the 4 node cluster

ManiA

Posted: Thu Jan 26, 2006 2:36 pm Post subject: Listener setup for MQ on MSCS

Newbie

Joined: 25 Jan 2006
Posts: 8

Hi andrewc,

I'm having trouble setting up a Listener to failover along with the QMgr in a MSCS environment.

Should the Listener be created normally or using Custom Service? Should the Listener be created prior to putting the QMgr into MSCS control? or can it be created afterward?

I'm setting up a MQ environment on a MQ5.3 csd11 on Windows 2003.

The chapter 13 on SAG doesn't seem to provide much directions about this topic. Maybe you can help me with some advise. Any pointers?

Thank you in advance!

prasadam

Posted: Fri Jan 27, 2006 12:36 pm Post subject:

Newbie

Joined: 11 Jul 2005
Posts: 4

Make node Ip address shared resource.
Run listener is independent on each node.
Set for autostart.
you need create listener from MQservices snap in once for each node.
And failover and back again to check listener working.

I did like this. On first failover it did not work.But on subsequent failover, it went through well.

Prasad.
_________________
I am who I am.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » MQ 5.3 on multinode MS Cluste with Windows 2003

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP