MQSeries.net :: View topic - Input Node Properties not being prompt

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Input Node Properties not being prompt

Input Node Properties not being prompt

« View previous topic :: View next topic »

Author

Message

bisu

Posted: Thu May 19, 2005 10:02 pm Post subject: Input Node Properties not being prompt

Apprentice

Joined: 05 Jan 2005
Posts: 25
Location: India

Hi
I am working on WBIMB v5.0.1(CSD 4) in WINDOWS 2000 SP 4. I am facing a problem that the input node properties are not prompting for the old message flows. If I drag a new input node then the properties abr prompting but the message sets in the workspace are not shown in the domain tab. Do u anybody have any idea.

Thanks in advance.

elvis_gn

Posted: Fri May 20, 2005 1:06 am Post subject:

Padawan

Joined: 08 Oct 2004
Posts: 1905
Location: Dubai

Hi,
First of all ur in the wrong place to ask a WBI question.

Anyway i think i have faced this issue. The problem is that u do not have the license to use the software.I think u will need a properties file from some computer where WBI works, next there is a command which I fail to remember.

This will fix the problem...If i can find the command i shall put it up, or you could try a search too..

Best of luck.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Input Node Properties not being prompt

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP