| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Applying CSD within MSCS |
« View previous topic :: View next topic » |
| Author |
Message
|
| bdrummond |
 Posted: Fri Apr 08, 2005 1:20 am Post subject: Applying CSD within MSCS |
 |
|
Disciple
Joined: 06 May 2004
Posts: 164
|
Hi,
I need to apply a CSD for MQ 5.3 on 2 QM's that are held within an MSCS cluster.
The Sys Admin Guide doesn't explain how to do this.
Has anyone had the need to do this and if so, what is the best (easiest) way..? |
|
| Back to top |
|
 |
| sebastianhirt |
| Posted: Fri Apr 08, 2005 1:35 am Post subject: |
|
|
Yatiri
Joined: 07 Jun 2004
Posts: 620
Location: Germany
|
Good morning,
As the Software itself is installed localy, I would think you have to do it on both of them.
Edit: I think my wording is not really good. New try  You have to install it on all nodes of a Hardware Cluster. This is also true for HACMP Clusters.
cheers
Sebastian |
|
| Back to top |
|
|
| PeterPotkay |
| Posted: Fri Apr 08, 2005 1:40 am Post subject: |
|
|
Poobah
Joined: 15 May 2001
Posts: 7722
|
Bring the QM offline on the node you want to apply the CSD, apply it, reboot for Bill Gates sake, and bring the QM up.
In an Active/Passive node, you can apply the CSD on the passive node that has no QM running, reboot, fail the QM from the Active node (old CSD still) to the node that has already been upgraded, and then apply the CSD to the previously active, now inactive, node, reboot. Failback the QM to the primary node if you wish.
_________________
Peter Potkay
Keep Calm and MQ On |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
