|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
 |
|
Doubt MQSeries ActiveX |
« View previous topic :: View next topic » |
Author |
Message
|
vjsony |
Posted: Thu Aug 02, 2001 7:53 pm Post subject: |
|
|
 Apprentice
Joined: 01 Aug 2001 Posts: 45
|
Hi,
I'm using MQSeries COM for programming. On an MQSeries client, my application works fine when connecting to a Qmgr on another m/c.
However in the case where both MQSeries client and server are on the same m/c, the application fails to connect to the Qmgr located on another m/c. Don't know why ... i've set up the client connection channel too ..
Is there anything I'm missing?
Waiting for your replies ...
Thanks,
VJ |
|
Back to top |
|
 |
kolban |
Posted: Fri Aug 03, 2001 1:45 pm Post subject: |
|
|
 Grand Master
Joined: 22 May 2001 Posts: 1072 Location: Fort Worth, TX, USA
|
VJ, The following is taken from the latest MQ COM manual on page 16:
| AccessQueueManager method
| Creates a new MQQueueManager object and connects it to a real queue manager
| by means of the MQSeries client or server. As well as performing a connect, this
| method also performs an open for the queue manager object.
| Note: When both the MQSeries server and client are installed on your system
| MQAX applications will always run against the server.
Basically, if an MQSeries Server IS installed on the same machine as the ActiveX program THEN that program can ONLY connect to the local queue manager.
Don't ask ... I don't like it either
Now an FAQ entry
[ This Message was edited by: kolban on 2001-09-03 18:29 ] |
|
Back to top |
|
 |
vjsony |
Posted: Sat Aug 04, 2001 12:47 am Post subject: |
|
|
 Apprentice
Joined: 01 Aug 2001 Posts: 45
|
Thanks for the reply ... that's not very good now ,isn't it?!! |
|
Back to top |
|
 |
|
|
 |
|
Page 1 of 1 |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
|