| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| no messagetransfer |
« View previous topic :: View next topic » |
| Author |
Message
|
| relheop |
 Posted: Mon Jul 05, 2004 2:15 am Post subject: no messagetransfer |
 |
|
Apprentice
Joined: 30 Jan 2003
Posts: 40
|
We have a connection z/os to tandem. Normally it works ok, but sometimes we have a big problem:
Send-channel z/os in status running, messages in the transmissionqueue and the receiver on tandem have status inactive.
Note: MQS 2.2.0.1 on Tandem have no HBINT, HBINT on MQS 2.1 on z/os 300 sec and disconnect on send-channel 600 sec. Keepalive active on both
We need help, what´s the reason? What can we do? We have candle for MQSeries, but we can´t monitor this situation. |
|
| Back to top |
|
 |
| mgrabinski |
| Posted: Wed Jul 07, 2004 1:23 am Post subject: |
|
|
Master
Joined: 16 Oct 2001
Posts: 246
Location: Katowice, Poland
|
I see two problem areas in your post:
1) If a channel is running, it transfers messages from its xmitq. If however you see messages in the xmitq and they are not being sent over, it means that they haven't been committed by the putting application.
2) When the receiving end is inactive and sending end is running, but no there are no messages to transfer, the way to close down the channel is a heartbeat flow. In your case its not possible, so try to decrease the disconnect interval (and setup the channel to be triggered)
_________________
Marcin Grabinski <>< |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
