| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Control Centers out of sync |
« View previous topic :: View next topic » |
| Author |
Message
|
| MikeC |
 Posted: Mon Jun 07, 2004 9:18 am Post subject: Control Centers out of sync |
 |
|
Acolyte
Joined: 30 Jun 2003
Posts: 55
Location: Toronto, Canada
|
One of our developers has created a new flow and saved it to the configuraton manager. When I connect to the configuration manager, I can't see the flow. I've refreshed my view from the Shared configuration. I've tried to add a flow to my workspace, but the new one isn't there. No errors were received when the flow was checked in and Event Viewer shows nothing. ... I'm responsible for doing the deploys, so I'm dead in the water until I can figure out why I'm not seeing this flow.
... Any ideas why it would be visible from the control center that checked it in and not from mine??
-Thanks.
_________________
-Mike. |
|
| Back to top |
|
 |
| Missam |
| Posted: Mon Jun 07, 2004 9:25 am Post subject: |
|
|
Chevalier
Joined: 16 Oct 2003
Posts: 424
|
| Did u connected to the same configmgr to which your developer has checked in the messageflow...? |
|
| Back to top |
|
|
| GYR |
| Posted: Mon Jun 07, 2004 9:30 am Post subject: |
|
|
Acolyte
Joined: 23 Jan 2002
Posts: 72
|
Two things firstly
If you can not see it it in the config manager and you are both definetely connected to the same config manager (you may want to recheck your connection, unless you only have one config manager of course) then it has probably not been saved there. Your colleague will be able to see it in his CC because the flow is "saved" locally until you have checked it in and only then is it put to the config manager and avail for all to see. You could try geting your colleague to check it out again and re-check it in to ensure there were no ODBC errors to the Config manager DB (the event log would probably have this if there were). the other things to check are that you are signed on with a profile that allows you to see flows etc the mqbrdevt group ( I am assuming you are and therefore is just a thought). |
|
| Back to top |
|
|
| MikeC |
| Posted: Tue Jun 08, 2004 10:03 am Post subject: |
|
|
Acolyte
Joined: 30 Jun 2003
Posts: 55
Location: Toronto, Canada
|
Thanks for the suggestions guys. ..... It turns out the developer had me looking for the wrong flow name. 
_________________
-Mike. |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
