| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Unable to see any MRM after reading the message from Q |
« View previous topic :: View next topic » |
| Author |
Message
|
| girneer |
 Posted: Fri May 14, 2004 12:38 pm Post subject: Unable to see any MRM after reading the message from Q |
 |
|
Newbie
Joined: 13 May 2004
Posts: 7
|
I have configured WMQI 2.1 and created Message Set, Flow, Broker, Execution Set etc. and start the Debugger.
I just have MQInput and MQOutput nodes in the message flow. i have put a break point after input node.
Execution Flow gets initiated and MQMD and MRM nodes appear in the "Message Content" pane. MQMD is filled with the values. MRM is empty.
I have applied CSD04.
Any hints will be greatly appriciated.
Any sample message sets - SWIFT related?
Thanks a lot.
I am using bulk load utility to load the message set into WMQI. |
|
| Back to top |
|
 |
| jefflowrey |
| Posted: Sat May 15, 2004 3:22 pm Post subject: |
|
|
Grand Poobah
Joined: 16 Oct 2002
Posts: 19981
|
There is at least one support pack available that discusses SWIFT messages.
If you are not seeing any MRM data, this is likely because you have done nothing to cause the message data to be parsed.
WMQI is a lazy parsing machine, always. It will parse no field before it's time.
Try enabling validation on your Input Node.
_________________
I am *not* the model of the modern major general. |
|
| Back to top |
|
|
| girneer |
| Posted: Tue May 25, 2004 6:05 pm Post subject: |
|
|
Newbie
Joined: 13 May 2004
Posts: 7
|
Couple of points (found by hard-way by going throu the entire stack of elements, types and messages provided with id06)
1. msgStd should be set to "UNKNOWN"
2. If msgStd is set to "SWIFT", the vardelim doesnot work as expected.
3. Try with a simple message say MT199.
4. Some issues with Type="DEC" and "Date", so be careful
With the above changes, I am able to proceed to load SWIFT definition into MRM using Bulk load utility. Also, able to parse the message using WMQI. Thanks for all the hints/feedbacks |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
