MQSeries.net :: View topic - how to connect brokers of different configuration managers

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » how to connect brokers of different configuration managers

how to connect brokers of different configuration managers

« View previous topic :: View next topic »

Author

Message

lwl

Posted: Tue May 04, 2004 6:09 pm Post subject: how to connect brokers of different configuration managers

Apprentice

Joined: 30 Mar 2004
Posts: 41

Hi all,

we use event broker v2.1. We now have 2 brokers. They are connecting to separate configuration managers. We use the brokers for pub/sub purpose. The pub/sub works fine on its own. I would like to know how to connect the two brokers together, so that the pub/sub messages can be exchanged between them. I know that "collective" is a way if the two brokers are using the same configuration managers. But how to connect them if they are of different configuration managers?

thank you,
lwl

Nizam

Posted: Tue May 04, 2004 8:32 pm Post subject:

Disciple

Joined: 10 Feb 2004
Posts: 160

Just create brokers and define channel between them and a listener so that they can communicate.
Add the two brokers in the broker domain.....
I guess this is all you need to do..

lwl

Posted: Tue May 04, 2004 10:22 pm Post subject:

Apprentice

Joined: 30 Mar 2004
Posts: 41

how to add the brokers to the broker domain?? Any command to do that?

Nizam

Posted: Wed May 05, 2004 5:46 am Post subject:

Disciple

Joined: 10 Feb 2004
Posts: 160

Refer to the Manual Using the Control Center Version 2.1 SC34-5602-05.
That should solve your problem.

Missam

Posted: Wed May 05, 2004 5:53 am Post subject:

Chevalier

Joined: 16 Oct 2003
Posts: 424

I don't know whether there is any command to do this.But you can Connect brokers from the Control Center Topology View.
Check out Topology
Right click on the Broker you want to Connect to Other,and say connect port .(Assuming you have proper channels defined between your broker QM's)

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » how to connect brokers of different configuration managers

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP