MQSeries.net :: View topic - Change properties Remote Q --> fails to put

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Change properties Remote Q --> fails to put

Change properties Remote Q --> fails to put

« View previous topic :: View next topic »

Author

Message

Duke

Posted: Wed May 05, 2004 5:21 am Post subject: Change properties Remote Q --> fails to put

Apprentice

Joined: 09 Mar 2004
Posts: 49
Location: Belgium

Dear all,

When you change the properties of a remote queue that the broker used to send messages with the MQSeries explorer then the broker is no more able to put messages on the remote queue.

In the version 2.4 it was possible to perform a complete deploy on the broker.
But I don't know if it is possible to do the same with the V5.
I have tried to right click on broker topology and then deploy complete but it doesn't solve the problem.

Is any one have an idea?
_________________
Pierre Richelle

Engineer
IBM Certified MQSeries Developper V5.3
IBM Certified WMQ Administration V6

Posted: Wed May 05, 2004 9:01 am Post subject:

Padawan

Joined: 27 Mar 2003
Posts: 1564
Location: Hartford, CT.

In v5.x you have the mqsireload command to request the broker to stop and restart execution groups. This results in the message flows re-acquiring resources used by the nodes and parsers within.

EddieA

Posted: Wed May 05, 2004 10:28 am Post subject:

Jedi

Joined: 28 Jun 2001
Posts: 2453
Location: Los Angeles

Quote:

In v5.x you have the mqsireload command

Not just v5. It's also available in v2.1.

Cheers,
_________________
Eddie Atherton
IBM Certified Solution Developer - WebSphere Message Broker V6.1
IBM Certified Solution Developer - WebSphere Message Broker V7.0

Duke

Posted: Wed May 05, 2004 9:20 pm Post subject:

Apprentice

Joined: 09 Mar 2004
Posts: 49
Location: Belgium

Hi,

Thank you very much, I will try it

.
_________________
Pierre Richelle

Engineer
IBM Certified MQSeries Developper V5.3
IBM Certified WMQ Administration V6

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Change properties Remote Q --> fails to put

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP