MQSeries.net :: View topic - How to setup dlq handler on as/400 ! its urgent

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » General Discussion » How to setup dlq handler on as/400 ! its urgent

How to setup dlq handler on as/400 ! its urgent

« View previous topic :: View next topic »

Author

Message

brgmo

Posted: Sun Feb 22, 2004 12:42 pm Post subject: How to setup dlq handler on as/400 ! its urgent

Master

Joined: 03 Jun 2002
Posts: 227

Hi All

Can somebody guide me as how to setup a dead letter queue and dead letter queue handle in case of as/400. As well how to define the rules table for that and how to associate it with the dead lettet queue handler. Any other extra information is very much needed.

Thanks in advance
brgmo.

RogerLacroix

Posted: Sun Feb 22, 2004 9:53 pm Post subject:

Jedi Knight

Joined: 15 May 2001
Posts: 3264
Location: London, ON Canada

Hi,

Have you read the manual? Are you stuck on a particular section? What have you done so far? Are you looking for someone to do the work for you? (i.e. hiring a consultant?)

Considering there is a whole chapter dedicated to the dead letter handler in the WMQ System Administration Guide (for AS/400), I would strongly suggest that you read the chapter and that you follow its suggestions if you are doing it yourself.

Hope that helps.

Regards,
Roger Lacroix

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » General Discussion » How to setup dlq handler on as/400 ! its urgent

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP