| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| problems getting trigger monitor messages |
« View previous topic :: View next topic » |
| Author |
Message
|
| vivekkooks |
 Posted: Mon Feb 02, 2004 3:53 am Post subject: problems getting trigger monitor messages |
 |
|
Voyager
Joined: 11 Jun 2003
Posts: 91
|
Hello,
I have MQ Series running with trigger monitors.
But if I rename the executable which trigger monitor should start, I can see the message displayed on to the console mentioning executable not found.
But in this case, the trigger monitor does not write a message into DEAD LETTER QUEUE mentioning this error.
So, how can I trap this error? |
|
| Back to top |
|
 |
| vivekkooks |
| Posted: Wed Feb 04, 2004 2:09 am Post subject: |
|
|
Voyager
Joined: 11 Jun 2003
Posts: 91
|
| Any help on the above issue? |
|
| Back to top |
|
|
| fschofer |
| Posted: Wed Feb 04, 2004 2:51 am Post subject: |
|
|
Knight
Joined: 02 Jul 2001
Posts: 524
Location: Mainz, Germany
|
Hi,
i have tried this one my own.
First there also were no messages in the dead letter queue, but then i found my error:
I had no dead letter queue defined for the qm. After i defined it and restarted the qm,
the trigger messages are put to the DLQ as expected. |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
