MQSeries.net :: View topic - how to configure channel exits programmatically?

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » how to configure channel exits programmatically?

how to configure channel exits programmatically?

« View previous topic :: View next topic »

Author

Message

Anuradha Bose

Posted: Thu Jan 08, 2004 10:08 pm Post subject: how to configure channel exits programmatically?

Newbie

Joined: 08 Jan 2004
Posts: 7

The only way I know to define channel exits is thru MQSC when defining a channel. Is there a way thru a code I can configure channel exits given a channel name?

thanks
a.bose

JasonE

Posted: Fri Jan 09, 2004 2:07 am Post subject:

Grand Master

Joined: 03 Nov 2003
Posts: 1220
Location: Hursley

Look at the programmable command formats (PCF) manual under the section Change, Copy, Create Channel. Remember most of the things the GUI Explorer does is done via PCF commands (which is how remote admin works) so you can do almost anything in PCF that the GUI does.
Note I dont think the mainframe supports PCF commands

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » how to configure channel exits programmatically?

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP