| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| rumqdlq rules table directives do not work |
« View previous topic :: View next topic » |
| Author |
Message
|
| mayel |
 Posted: Wed Sep 24, 2003 8:39 am Post subject: rumqdlq rules table directives do not work |
 |
|
Newbie
Joined: 03 Sep 2003
Posts: 6
Location: colorado springs CO USA
|
Hello Everyone,
I have tried the following line in a rules table file:
REASON(MQRC_PUT_INHIBITED) ACTION(RETRY) RETRY(24) RETRYINT(360)
but when I run the program I get the following:
runmqdlq < mqdlq.script.COS1B.msg.archive
syntax error on line 30
...RETRYINT
2003-09-24 10.33.03 AMQ8753: Duplicate parameter(ACTION) found on line 36.
2003-09-24 10.33.03 AMQ8758: 2 errors detected in input to runmqdlq.
2003-09-24 10.33.03 AMQ8709: Dead-letter queue handler ending.
As it turns out when I disected the directives, and then I remove the RETRYINT(360) it works fine, all the other directives work fine.
Also it seams that even though the default RETRYINT is 60 seconds, the ACTION(RETRY) is performed immediatly.
Any ideas?
Best Regards,
Mayel ><>
_________________
Best Regards,
Mayel ><> |
|
| Back to top |
|
 |
| mayel |
| Posted: Wed Sep 24, 2003 11:00 am Post subject: eureka |
|
|
Newbie
Joined: 03 Sep 2003
Posts: 6
Location: colorado springs CO USA
|
I found the problem, the RETRYINT directive does work, when placed in the inptqm line, for example :
inputqm('') inputq('') RETRYINT(60)
Best Regards.
Mayel ><>
_________________
Best Regards,
Mayel ><> |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
