| Author |
Message
|
| ljbeck |
 Posted: Thu Dec 30, 2004 11:56 am Post subject: Using Visual Edit to connect to Queues defined in WSAD |
 |
|
Newbie
Joined: 30 Dec 2004
Posts: 4
|
I am trying to determine if I can use Visual Edit to connect to queues that I have defined in WSAD5.1.1.
I have read that the implementation of MQ included is limited and does not allow external connections.
 I assume that this means I will not be able to connect but if there is a way I would like to know how.
Any ideas??
You help is appreciated.  |
|
| Back to top |
|
 |
| RogerLacroix |
| Posted: Thu Dec 30, 2004 12:27 pm Post subject: |
|
|
Jedi Knight
Joined: 15 May 2001
Posts: 3264
Location: London, ON Canada
|
Hi,
Thanks for your interest in MQ Visual Edit.
Yes, MQ Visual Edit can connect to the embedded queue manager in WSAD - the only thing you need is the queue manager name (and it be running).
If you do not know the name of your queue manager then do the following:
| Quote: |
- Open Command Prompt
- cd {WSAD_MQ_INSTALL_DIR}\bin
- dspmq |
dspmq will return the name of your queue manager and status info (i.e. running). Once you have the queue manager name, then in MQ Visual Edit, add a new 'Queue Manager Access Profile'. Note: Do not put any information in the Remote Parameter or Security Exit sections.
Hope that helps.
Regards,
Roger Lacroix
Capitalware Inc.
_________________
Capitalware: Transforming tomorrow into today.
Connected to MQ!
Twitter |
|
| Back to top |
|
|
| ljbeck |
| Posted: Mon Jan 03, 2005 5:25 am Post subject: |
|
|
Newbie
Joined: 30 Dec 2004
Posts: 4
|
Roger,
Thanks for you help.
Your instructions worked perfectly!
The way the response from the dspmq command looked was:
QMNAME(WAS_localhost_server1) STATUS(Running)
So in this case the queue manager name is "WAS_localhost_server1".
(The parenthesis threw me for about a half a second.)
That was all I needed.
This makes MQ Visual Edit even more useful.
Thanks again! |
|
| Back to top |
|
|
| jgbriggs |
| Posted: Mon Feb 07, 2005 9:25 am Post subject: Doesn't work with version MQ Visual Edit 1.3.1? |
|
|
Guest
|
I previously used this tip to connect with an older version of MQ Visual Edit, but with the new version (1.3.1) I am having some problems.
I get an error that "the procedure entry point lpiSPISyncPoint could not be located in the dynamic link library AMQZST.dll"  |
|
| Back to top |
|
|
| RogerLacroix |
| Posted: Mon Feb 07, 2005 11:13 am Post subject: |
|
|
Jedi Knight
Joined: 15 May 2001
Posts: 3264
Location: London, ON Canada
|
|
| Back to top |
|
|
| Guest |
| Posted: Mon Feb 07, 2005 11:57 am Post subject: |
|
|
|
Thank you for your speedy reply!
Your instructions worked like a charm!
Very helpful, thank you |
|
| Back to top |
|
|
|
|
