| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Automating RQSTR Channel Restart After Security Refresh |
« View previous topic :: View next topic » |
| Author |
Message
|
| bibis |
 Posted: Wed Mar 05, 2025 11:50 am Post subject: Automating RQSTR Channel Restart After Security Refresh |
 |
|
Newbie
Joined: 31 May 2022
Posts: 1
|
Hi,
My MQ server (QMINE) is behind a NAT, so it is not directly reachable from the network. However, my vendor?s MQ server (QVENDOR) is publicly accessible, allowing me to connect from QMINE → QVENDOR without issues.
Since traffic needs to flow in both directions, I have configured a Requester (RQSTR) channel on my side and a Server (SVR) channel on QVENDOR. The default Sender/Receiver (SDR/RCVR) channel setup would not work because QMINE has no public IP and is not reachable externally.
Issue:
QVENDOR shares its MQ server with other systems and occasionally updates its certificates. When they do this, they run REFRESH SECURITY, which disrupts the connection. Afterward, I have to manually stop and restart the RQSTR channel for it to reconnect.
Question:
Is there a way to automate this process so I don?t have to manually restart the RQSTR channel each time QVENDOR refreshes its security settings?
Thanks!
Bart |
|
| Back to top |
|
 |
| hughson |
| Posted: Fri Mar 14, 2025 2:16 am Post subject: |
|
|
Padawan
Joined: 09 May 2013
Posts: 1959
Location: Bay of Plenty, New Zealand
|
You appear to have copied Peter's question from here. Please read the answer I wrote there.
_________________
Morag Hughson @MoragHughson
IBM MQ Technical Education Specialist
Get your IBM MQ training here!
MQGem Software |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
