| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| RM Worker Not Found |
« View previous topic :: View next topic » |
| Author |
Message
|
| marior |
 Posted: Thu Jul 31, 2003 5:18 am Post subject: RM Worker Not Found |
 |
|
Newbie
Joined: 05 Jun 2003
Posts: 4
|
Hi,
I'm new to WMQI and struglling with an exception I'm getting when debugging one of my message flows. It is a simple INPUT Q -> COMPUTE NOTE -> OUTPUT Q flow. The Compute node has a MRM as input and another as output. The message is fine up until it has to be placed on the output queue, then it throws out the exception "RM Worker Not Found".
I've validated the message in the flow to the Message Set and it looks fine. I have also checked that bipxmlworker.wrk file is in the
<MQSI dir>\bin directory (for Win 2000) and it is.
Any other ideas of what causes this, or what I could check?
T.I.A. |
|
| Back to top |
|
 |
| kimbert |
| Posted: Thu Jul 31, 2003 6:31 am Post subject: |
|
|
Jedi Council
Joined: 29 Jul 2003
Posts: 5542
Location: Southampton
|
I think I remember this one. The MRM parser is unable to find a message definition for the output message.
Check that the Message Set, Message Type, Domain (MRM) and Message Format are all correctly specified. Often, the Message Format is the culprit (you must use the Wire Format Identifier, which is not always the same as the title of the Wire Format tab in Control Center).
If all else fails, put a trace node after the Compute node, and see what it tells you. |
|
| Back to top |
|
|
| marior |
| Posted: Mon Aug 04, 2003 4:56 am Post subject: |
|
|
Newbie
Joined: 05 Jun 2003
Posts: 4
|
| Thanks Kimbert, you were right on the money! Message format was the culprit. |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
