ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » Workflow Engines - IBM MQ Workflow & Business Process Choreographer » How do Logon3 and Logon4 work

Post new topic  Reply to topic
 How do Logon3 and Logon4 work « View previous topic :: View next topic » 
Author Message
Ratan
PostPosted: Thu May 22, 2003 11:02 am    Post subject: Reply with quote

Grand Master

Joined: 18 Jul 2002
Posts: 1245

John,

Sorry for misleading. I was under the impression that I will be able to change any users password. just verified the API calls and you are right I can only change the logged on users password ( From now on, I should first verify and then try to answer).

Looking at the API calls, I am also under the impression that I can do some tricks and get this done. I think I can use the executionservers PassThrough call to login (this would require the activity assigned to a process starter, and set the process starter to the person you want to change the password for). Do you think it will work?

how do logon3 and logon4 work ( I am completely ignorant). I am under the impression I can do some tricks to logon with out specifying a password, which implies I can set the password.

Of course even if these approaches work they are much difficult than the FDL process.
_________________
-Ratan
Back to top
View user's profile Send private message Send e-mail
jmac
PostPosted: Thu May 22, 2003 11:38 am    Post subject: Reply with quote

Jedi Knight

Joined: 27 Jun 2001
Posts: 3081
Location: EmeriCon, LLC

Ratan:

Logon3 should not be used, it exists only for compatibility.

Logon4 is used with an Authentication Exit. And yes, this would allow you to login without the use of a password, assuming that your Exit allowed this.

There is some doc on using an Authentication exit in the Programming guide. I have played with them a little bit, and have not found them to be too difficult to deal with.

GOOD LUCK
_________________
John McDonald
RETIRED
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address Yahoo Messenger MSN Messenger
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » Workflow Engines - IBM MQ Workflow & Business Process Choreographer » How do Logon3 and Logon4 work
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
 
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.