| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| mqsi profile |
« View previous topic :: View next topic » |
| Author |
Message
|
| swann |
 Posted: Sat Dec 03, 2011 8:37 am Post subject: mqsi profile |
 |
|
Acolyte
Joined: 21 Jun 2011
Posts: 50
|
Hi,
I have installed the MB 7 on aix on usr/mqbroker filesystem.I tried to source the mqsiprofile by . ./mqsiprofile on /usr/mqbroker/bin the it was showing the MB version installed.But when i tried to run mqsi commands it shows the following error:
Failed to open file /var/mqsi/registry/utility/HASharedWorkPath with error The file access permissions do not allow the specified action.
BIP2113E: Message broker internal error: diagnostic information ''The file access permissions do not allow the specified action.'', '13', ''/var/mqsi/registry/utility/HASharedWorkPath''.
An internal software error has occurred in the message broker. Further messages will indicate the effect of this error on the broker's transactions.
Shutdown and restart the message broker. If the problem continues to occur, then restart the system. If the problem still continues to occur contact your IBM support center.
BIP8081E: An error occurred while processing the command.
An error occurred while the command was running; the command has cleaned up and ended.
Use messages prior to this one to determine the cause of the error.
Check for some common problems:
Does the user id have the correct authorities (for example a member of the mqbrkrs group)?
Is any operating system limit set too low to allow the command to run?
Is the environment correctly set up?
Correct the problem and retry the command, otherwise, contact your IBM support center.
So could anyone help how to solve this problem, i mean how to run the mqsi commands? |
|
| Back to top |
|
 |
| exerk |
| Posted: Sat Dec 03, 2011 10:18 am Post subject: |
|
|
Jedi Council
Joined: 02 Nov 2006
Posts: 6339
|
Moving this to the BROKER forum, where it belongs... 
_________________
It's puzzling, I don't think I've ever seen anything quite like this before...and it's hard to soar like an eagle when you're surrounded by turkeys. |
|
| Back to top |
|
|
| Vitor |
| Posted: Sat Dec 03, 2011 12:39 pm Post subject: Re: mqsi profile |
|
|
Grand High Poobah
Joined: 11 Nov 2005
Posts: 26093
Location: Texas, USA
|
| swann wrote: |
| So could anyone help how to solve this problem, i mean how to run the mqsi commands |
I don't think this is helping:
| swann wrote: |
Failed to open file /var/mqsi/registry/utility/HASharedWorkPath with error The file access permissions do not allow the specified action.
BIP2113E: Message broker internal error: diagnostic information ''The file access permissions do not allow the specified action.'', '13', ''/var/mqsi/registry/utility/HASharedWorkPath''. |
Was the install performed correctly, i.e. any install errors?
Have the sys admins made any changes post-install, possibly to "standardize" the file system to site standards?
Looking at the file permissions, should the id have permission?
_________________
Honesty is the best policy.
Insanity is the best defence. |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
