| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| MQIPT over HTTP |
« View previous topic :: View next topic » |
| Author |
Message
|
| goblin |
 Posted: Thu May 27, 2010 5:19 am Post subject: MQIPT over HTTP |
 |
|
Newbie
Joined: 27 May 2010
Posts: 2
|
Hello,
I have a question concerning WebSphere MQ internet pass-thru, v2.
I have read the docs and searched this forum trying to find out if the following config is supported, MQ<-->IPT1<-->IPT2<-->MQ where the communication between the two IPT is using HTTP.
If this is supported, how do I configure...? if i use MQ all works fine.
Maybe there has to be a proxy between IPT1 and IPT2?
Thanks, |
|
| Back to top |
|
 |
| wschutz |
| Posted: Thu May 27, 2010 3:04 pm Post subject: Re: MQIPT over HTTP |
|
|
Jedi Knight
Joined: 02 Jun 2005
Posts: 3316
Location: IBM (retired)
|
| goblin wrote: |
Hello,
I have a question concerning WebSphere MQ internet pass-thru, v2.
I have read the docs and searched this forum trying to find out if the following config is supported, MQ<-->IPT1<-->IPT2<-->MQ where the communication between the two IPT is using HTTP.
If this is supported, how do I configure...? if i use MQ all works fine.
Maybe there has to be a proxy between IPT1 and IPT2?
Thanks, |
Thats what IPT does ...
MQ SVR - IPT - HTTP - IPT - MQ SVR.
Are you saying that it doesn't work? What have you tried?
_________________
-wayne |
|
| Back to top |
|
|
| goblin |
| Posted: Thu May 27, 2010 10:46 pm Post subject: |
|
|
Newbie
Joined: 27 May 2010
Posts: 2
|
Hello,
My question is if I can have the setup MQ<-->IPT1<-->IPT2<-->MQ and not going through an HTTP proxy like MQ<-->IPT1<-->HTTP proxy<-->IPT2<-->MQ
When I try without specifying an HTTP proxy in IPT1, using config like:
[route]
Name=Test1
ListenerPort=1415
Destination=xxx.xxx.xxx
DestinationPort=1418
OutgoingPort=0
HTTP=true
I get:
MQCPE042 There is a conflict with the following properties on route 1415 :
MQCPE045 ....HTTP proxy or server name is missing
MQCPE048 Route startup failed on port 1415, exception was : IPTException: closeI
d=, closeMsg=MQCPE056 Conflict with route properties, rc=0
Thanks, |
|
| Back to top |
|
|
| fjb_saper |
| Posted: Fri May 28, 2010 1:10 pm Post subject: |
|
|
Grand High Poobah
Joined: 18 Nov 2003
Posts: 20756
Location: LI,NY
|
Ah but you left http=true in your config.
You can use MQ<->IPT<->IPT<->MQ but the protocol will be MQ and not http.
Have fun 
_________________
MQ & Broker admin |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
