ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » IBM MQ Performance Monitoring » Any way to get the Msg Id by monitoring the recv channel ?

Post new topic  Reply to topic
 Any way to get the Msg Id by monitoring the recv channel ? « View previous topic :: View next topic » 
Author Message
jayeshn
PostPosted: Wed Jun 14, 2006 10:06 am    Post subject: Any way to get the Msg Id by monitoring the recv channel ? Reply with quote

Newbie

Joined: 14 Jun 2005
Posts: 7
Location: India

Hi,
We have an environment where there are frontend and backend queue managers and we have the hub qmgrs in the middle which do the routing and transformation. While testing/debugging we monitor the receiver channel on a hub qmgr. If its seq number goes up, we know that it got a message. But it does not tell me if its the message I am looking out for. Then we have to monitor the queues (audit/failure queues) to find out where this message went.
Is there any way in which I can get the message identifier by monitoring only the channels, so that it saves me from monitoring the queues? If not is there any other alternate way which would save me from monitoring all the queues on the hub?
_________________
Thanks,
Jayesh
Back to top
View user's profile Send private message Send e-mail
jefflowrey
PostPosted: Wed Jun 14, 2006 11:08 am    Post subject: Reply with quote

Grand Poobah

Joined: 16 Oct 2002
Posts: 19981

You could write a channel exit, either a sender-reciever pair of exits or a message exit, that would log or record the message ID.

You could write an API exit that would log or record the message id when it was put on any queue along with the queue name.

You could use report messages, I think the COD report will tell you which queue it ended up on.

In v6, you can use the new message auditing/tracing reports to find out where the message is at each step of the way.
_________________
I am *not* the model of the modern major general.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » IBM MQ Performance Monitoring » Any way to get the Msg Id by monitoring the recv channel ?
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
 
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.