| Author |
Message
|
| sirsi |
 Posted: Fri May 12, 2006 1:21 pm Post subject: DOCTYPE -- MRM domain |
 |
|
Disciple
Joined: 11 Mar 2005
Posts: 177
|
Hi,
I am trying to set the following doctype in a xml message.
<!DOCTYPE SEQUENCE_MESSAGE SYSTEM "sequence_message.dtd">
Message domain is MRM
wire format is XML
have unchecked the "suppress doctype" in .mset and have set all values to empty ( i.e., for system ID , public ID )
in message definition file, under "XML Document type settings" , i have set 'DOCTYPE System ID' to "sequence_message.dtd"..
my problem is i am not getting the required DOCTYPE in the output xml message. |
|
| Back to top |
|
 |
| sirsi |
| Posted: Sat May 13, 2006 9:12 pm Post subject: |
|
|
Disciple
Joined: 11 Mar 2005
Posts: 177
|
| am i missing something very basic here?... tried searching the forum but couldnt find something helpfull |
|
| Back to top |
|
|
| kimbert |
| Posted: Mon May 15, 2006 12:53 am Post subject: |
|
|
Jedi Council
Joined: 29 Jul 2003
Posts: 5542
Location: Southampton
|
| Quote: |
| my problem is i am not getting the required DOCTYPE in the output xml message. |
What are you getting instead? Does the output message have an incorrect DOCTYPE. or no DOCTYPE at all? |
|
| Back to top |
|
|
| sirsi |
| Posted: Mon May 15, 2006 10:53 am Post subject: |
|
|
Disciple
Joined: 11 Mar 2005
Posts: 177
|
| i am not getting DOCTYPE at all... Am i setting it properly? |
|
| Back to top |
|
|
| kimbert |
| Posted: Tue May 16, 2006 4:55 am Post subject: |
|
|
Jedi Council
Joined: 29 Jul 2003
Posts: 5542
Location: Southampton
|
Sorry - nothing springs to mind. I'm assuming that you also unchecked 'Suppress DocType' in the message definition file settings  |
|
| Back to top |
|
|
| madi |
| Posted: Tue May 16, 2006 5:54 am Post subject: |
|
|
Chevalier
Joined: 17 Jan 2006
Posts: 475
|
| Quote: |
in message definition file, under "XML Document type settings" , i have set 'DOCTYPE System ID' to "sequence_message.dtd"..
|
what did you mean msg def file ...... there is a 'DOCTYPE System ID' in the mset "XML Document type settings" ...... you meant that right ??
i had this problem once and i had to RCD to XML and add the DocType !!
the normal procedure is uncheck the 'supress doctype' and give the doctype in the fields below it and it should work.
Also how are you viewing your messages, sometimes the tools like RHFUtil don't display the Doctype
--madi |
|
| Back to top |
|
|
| sirsi |
| Posted: Tue May 16, 2006 11:32 am Post subject: |
|
|
Disciple
Joined: 11 Mar 2005
Posts: 177
|
yes i do have unchecked 'Suppress DocType' in the message definition file settings.
I am looking messages in Rfhutil, will check if something pops up after copying the message contents to a file
I will also RCD it to XML and try.
Thanks guys |
|
| Back to top |
|
|
|
|
