| Author |
Message |
 Topic: Unable to see any MRM after reading the message from Q |
girneer
Replies: 2
Views: 1687
|
 Forum: WebSphere Message Broker (ACE) Support Posted: Tue May 25, 2004 6:05 pm Subject: Unable to see any MRM after reading the message from Q |
Couple of points (found by hard-way by going throu the entire stack of elements, types and messages provided with id06)
1. msgStd should be set to "UNKNOWN"
2. If msgStd is set to "SWIFT", the varde ... |
| Topic: BIP1834E |
girneer
Replies: 6
Views: 3872
|
Forum: WebSphere Message Broker (ACE) Support Posted: Sun May 16, 2004 11:01 am Subject: Working using Bulk Load Utility.... |
I was loading the message set using bulkload utility (ID06).
If the ConfigMgr is down while using Bulk Load Utility, this problem arises.
Once we load the data then Config Mgr needs to be re-s ... |
| Topic: ConfigMgr and MRM inconsistent state |
girneer
Replies: 6
Views: 3173
|
Forum: WebSphere Message Broker (ACE) Support Posted: Sun May 16, 2004 10:56 am Subject: ConfigMgr and MRM inconsistent state |
Nothing notable in the db2diag.log.
I had the backup messageset. I had to delete and re-create the configmgr. Is there any other way? |
| Topic: Unable to see any MRM after reading the message from Q |
girneer
Replies: 2
Views: 1687
|
Forum: WebSphere Message Broker (ACE) Support Posted: Fri May 14, 2004 12:38 pm Subject: Unable to see any MRM after reading the message from Q |
I have configured WMQI 2.1 and created Message Set, Flow, Broker, Execution Set etc. and start the Debugger.
I just have MQInput and MQOutput nodes in the message flow. i have put a break point aft ... |
| Topic: ConfigMgr and MRM inconsistent state |
girneer
Replies: 6
Views: 3173
|
Forum: WebSphere Message Broker (ACE) Support Posted: Thu May 13, 2004 6:01 pm Subject: ConfigMgr Erro state |
I have the same problem after importing a new message set into WMQI 2.1
Is there any solution other than recreating the ConfigMgr?
Can I retain the message sets that are ok and delete (by any way) ... |
| Topic: BIP1834E |
girneer
Replies: 6
Views: 3872
|
Forum: WebSphere Message Broker (ACE) Support Posted: Thu May 13, 2004 5:42 pm Subject: BIP1834E |
The moment I click on the message set node, I am getting the error
Thanks. Is there a way to clean up/reconfigure the Config Mgr without losing all message sets. I have problem with only two of the ... |
| Topic: BIP1834E |
girneer
Replies: 6
Views: 3872
|
Forum: WebSphere Message Broker (ACE) Support Posted: Thu May 13, 2004 3:05 pm Subject: BIP1834E |
I am new to WMQI.
I am having same problem. Can you please tell me how to remove/delete the message set?
The moment I click on the message set node, I am getting the error. So, I am not able to ... |
