ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » General IBM MQ Support » CSQ1LOGP - Log print utility

Post new topic  Reply to topic
 CSQ1LOGP - Log print utility « View previous topic :: View next topic » 
Author Message
JAdams
PostPosted: Tue Mar 11, 2003 1:16 pm    Post subject: CSQ1LOGP - Log print utility Reply with quote

Apprentice

Joined: 11 Jul 2002
Posts: 47
Location: Lakeland, FL
Does anyone have any experience using this utility? I am running it according to the system admin guide and it runs for an extremely long time. My active log size is 13500 tracks and it is taking over 3-4 hours to dump one archive log.

Any assistance would be helpful
Jason
_________________
Jason Adams
IBM Certified Specialist MQSeries
Back to top
View user's profile Send private message
bob_buxton
PostPosted: Wed Mar 12, 2003 4:50 am    Post subject: Reply with quote

Master

Joined: 23 Aug 2001
Posts: 266
Location: England
Are you using an RBA range, or if you have 5.3) an LRSN range, to reduce the amount of data to a more manageable size.
_________________
Bob Buxton
Ex-Websphere MQ Development
Back to top
View user's profile Send private message
JAdams
PostPosted: Wed Mar 12, 2003 6:49 am    Post subject: Reply with quote

Apprentice

Joined: 11 Jul 2002
Posts: 47
Location: Lakeland, FL
No, but I did try to isolate it to a pageset. I did leave off some important information becuase I though it was the CSQ1LOQP program. I have applied the MO12 support pac and I am now thinking that is the problem. It looks like a loop in the module ( CCP1LRPL ) that the support pac was applied too. I have dedected this from running a STROBE report. I see that you are from Hursley. I just sent an email to Colin Paice explaining the problem. When I run this with a small (active logs are 100 cylinders) archive log it works fine...still runs a little long but it does not loop. When I use my production archive logs which are large (active logs are 900 cylinders) it starts to loop after about an 1 1/2 hours of running.
_________________
Jason Adams
IBM Certified Specialist MQSeries
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » General IBM MQ Support » CSQ1LOGP - Log print utility
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
  
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.