MQSeries.net :: View topic - Channel Status Stopping

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » General IBM MQ Support » Channel Status Stopping

Channel Status Stopping

« View previous topic :: View next topic »

Author

Message

rajmq

Posted: Tue Feb 18, 2003 1:47 am Post subject: Channel Status Stopping

Partisan

Joined: 29 Sep 2002
Posts: 331
Location: USA

Hi
I am Using MQ5.2.1NT Version, it is connected to AIX MQ5.2 Server using the Server to Server Communication.The Receiver channel i am not able to stop, it just stays at status 'stopping'. Even i stopped Sender channel on the remote end, But Again it is showing same!!
Here How to stop my Reveiver Channel??

Thanks in Advance

raj

pgorak

Posted: Tue Feb 18, 2003 1:58 am Post subject:

Disciple

Joined: 15 Jul 2002
Posts: 158
Location: Cracow, Poland

If you stop the receiver/requester channel it is not actually stopped, but rather waits for a heartbit flow from the sender/server side. As soon as it receives the heartbeat (or you try to send a message) it hangs up and stops and the sender side goes into RETRYING state. But until that moment the receiving side is in STOPPING state and the sending side in RUNNING state.

You should be able to stop the communications from the sending side, upon which the sending side goes into STOPPED state and the receiving side goes into INACTIVE state.

Piotr

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » General IBM MQ Support » Channel Status Stopping

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP