MQSeries.net :: View topic - How to configure SAP adapters in wmb v 8.0.0

sai297 · Posted: Wed Feb 06, 2013 1:55 pm Post subject:

i am usind IDOC type and i created one INBOUND message flow and i deployed successfully. when i am creating another INBOUND flow for other IDOC Type i am getting Error. This is the error.

Begin running task [Deploying [R3Link_Migr_MATMAS02.bar] to execution group [EG_SAP]]

BIP2087E: Broker PD1DEV was unable to process the internal configuration message.

The entire internal configuration message failed to be processed successfully.

Use the messages following this message to determine the reasons for the failure. If the problem cannot be resolved after reviewing these messages, contact your IBM Support center. Enabling service trace may help determine the cause of the failure.

BIP4041E: Execution group 'EG_SAP' received an invalid configuration message. See the following messages for details of the error.

The broker was asked to deploy a message flow which contained properties that were not recognized by the broker. This typically results from a message flow requiring a version or type of node that is not supported by the broker installation.

Check that the message flow is only using properties or nodes that are supported on the broker. Check that all necessary user-defined extensions are installed and that they are of a version that is compatible with the message flow.

BIP3415E: The deletion of the adapter component 'SAP_INBOUND_ADAPTER.inadapter' failed.

Review previous messages to find out why the error occurred.

BIP3403E: The adapter component 'SAP_INBOUND_ADAPTER.inadapter' cannot be deleted because it is in use by the following message flow nodes: SAP_INBOUND_ORDERS01.SAP Input.

You have attempted to delete an adapter component that is in use by one or more message flows.

Review the message flows that are using the adapter and delete any that are no longer required. Then retry deleting the adapter component.

The task was unsuccessful: The deployment was unsuccessful. Check error messages above for explanation.

How to create new flow for new idoc type.