| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| How to trace DynamicSubscriptionEngine of an EG? |
« View previous topic :: View next topic » |
| Author |
Message
|
| issac |
 Posted: Fri Dec 09, 2011 9:42 pm Post subject: How to trace DynamicSubscriptionEngine of an EG? |
 |
|
Disciple
Joined: 02 Oct 2008
Posts: 158
Location: Shanghai
|
Hello,
When I mqsireportproperties AAABK1 -e TEST_G1 -o DynamicSubscriptionEngine -a
I see attributes there named "traceLevel", and "userTraceLevel". Thus this object must be traceable. I successfully turned on the trace by mqsichangeproperties AAABK1 -e TEST_G1 -o DynamicSubscriptionEngine -n traceLevel -v trace, and recycled the broker. Then I deployed a bar. But I find nowhere to read the trace. Where is the trace please?
I tried mqsireadlog and checked in /var/mqsi/common/log folder, but nothing seems relevant to DynamicSubscriptionEngine.
Thank you!
_________________
Bazinga! |
|
| Back to top |
|
 |
| mqjeff |
| Posted: Sat Dec 10, 2011 7:31 am Post subject: |
|
|
Grand Master
Joined: 25 Jun 2008
Posts: 17447
|
I'm not sure you'll get any end-user relevant information from doing this.
If you are working a PMR on this, then ideally L3 or L2 will be providing you with instructions for how to gather this tracing information.
My personal guess would be that this tracing information is output to the EG level trace file. So either an mqsireadlog on the EG or on the EG uuid, and then search the resulting file for DynamicSubscriptionEngine.
Possibly it's in an agent.trace file.
Also, it might only be the 'master' EG that runs the DynamicSubscriptionEngine component. So you might not have enabled tracing of it on an EG that is actually using it.
This is all just speculation, however. Again, if you're working a PMR then you should get specific instructions on how to do this... |
|
| Back to top |
|
|
| Archu |
| Posted: Mon Dec 12, 2011 4:06 am Post subject: |
|
|
Novice
Joined: 17 Jun 2011
Posts: 16
|
Hi,
Where did u run mqsireadlog command? Please check in that path if you could fine a file specified in mqsireadlog command. |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
