ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » General IBM MQ Support » setmqaut issue on soalris 10

Post new topic  Reply to topic
 setmqaut issue on soalris 10 « View previous topic :: View next topic » 
Author Message
wilsonho3
PostPosted: Sun Apr 18, 2010 6:04 pm    Post subject: setmqaut issue on soalris 10 Reply with quote

Voyager

Joined: 20 Nov 2001
Posts: 98
Location: Hong Kong
Hi, all

I have problem in isuerring setmqaut in soalris 10 ebvironment :

please see the following:

NO OK

$ setmqaut -m COD1.queue_manager -t queue -n TPM005_PROPAGATE.ICRSCOP1_ZEBRA -p icrscop1 +allmqi
AMQ7047: An unexpected error was encountered by a command.

OK
$ setmqaut -m COD1.queue_manager -t queue -n TPM005_PROPAGATE.ICRSCOP1_ZEBRA -p mqm +allmqi
The setmqaut command completed successfully.

I belong MQM group and issue the above comamnd, one fine and the other
not.

NO error log found, anyone know what is the issue. please advise

regards

Wilson
Back to top
View user's profile Send private message Send e-mail
mqjeff
PostPosted: Mon Apr 19, 2010 2:21 am    Post subject: Reply with quote

Grand Master

Joined: 25 Jun 2008
Posts: 17447
don't use -p on Unix, use -g and group names.

It's the effective result anyway, the primary group of the user is authorized and not the user itself.

mqm presumably works because it's both a user and a group.
Back to top
View user's profile Send private message
exerk
PostPosted: Mon Apr 19, 2010 3:01 am    Post subject: Reply with quote

Jedi Council

Joined: 02 Nov 2006
Posts: 6339
mqjeff wrote:
...mqm presumably works because it's both a user and a group.


And I suspect is completely 'ignored' as mqm has implicit access to everything
_________________
It's puzzling, I don't think I've ever seen anything quite like this before...and it's hard to soar like an eagle when you're surrounded by turkeys.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » General IBM MQ Support » setmqaut issue on soalris 10
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
  
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.