MQSeries.net :: View topic - WMQ/WMB v7 Pub/Sub RFH2

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » WMQ/WMB v7 Pub/Sub RFH2

WMQ/WMB v7 Pub/Sub RFH2

« View previous topic :: View next topic »

Author

Message

bobbee

Posted: Tue Apr 06, 2010 5:54 pm Post subject: WMQ/WMB v7 Pub/Sub RFH2

Knight

Joined: 20 Sep 2001
Posts: 545
Location: Tampa

I am trying to get a RFH2 header to accompany a Published message from inside a flow using the publication node. I have the message matched to the subscription and ending up on the queue but the RFH2 header that contains the PSC and USR folder ends up being stripped off somewhere. My QMGR and Broker are both at v7 and are straight installs. I have NOT done anything with the Pub/Sub Compat attributes. The Pub/Sub Engine is running in MQ.

Do I have to bypass the Publication Node and write straight to MQ? I am putting the message to the input queue using RFHUTIL and putting a RFH2 header on it with a USR folder. I am then adding the PSC folder with the Command and Topic values. This all seems to work. Except the 'stripping' of the RFH2 Header.

smdavies99

Posted: Tue Apr 06, 2010 10:16 pm Post subject:

Jedi Council

Joined: 10 Feb 2003
Posts: 6076
Location: Somewhere over the Rainbow this side of Never-never land.

can you show the code where you are adding the RFH2 Header & populating it?
_________________
WMQ User since 1999
MQSI/WBI/WMB/'Thingy' User since 2002
Linux user since 1995

Every time you reinvent the wheel the more square it gets (anon). If in doubt think and investigate before you ask silly questions.

bobbee

Posted: Wed Apr 07, 2010 1:53 am Post subject:

Knight

Joined: 20 Sep 2001
Posts: 545
Location: Tampa

Ok, got some response from MQ/MBin what I was doing. I configured the PSPROP field onthe subscriptionand receivedthe RFH2header.The Name/Value pairs in the USR folder appeared in the messages on the destination.KEWL.

The RFH2 header was being constructed correctly, I did it in RFHUTIL to bypass any code issues I may have had. When I used RFHUTIL to publish the message it all worked great. It was when I took the same exact message and pushed it through Publication Node that the response was different. Seems like the processing is NOT the same. That bothers me. Anyway, got it working. On to the next wall.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » WMQ/WMB v7 Pub/Sub RFH2

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP