| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| How to setup subscriptions - Remote Linux server |
« View previous topic :: View next topic » |
| Author |
Message
|
| nickkirk |
 Posted: Thu Nov 13, 2008 3:48 am Post subject: How to setup subscriptions - Remote Linux server |
 |
|
Apprentice
Joined: 26 Sep 2008
Posts: 48
|
I can use rfhutil ( do not need rfhutilc ) to send messages to the remote Linux server where the broker resides.
This is done using a transmission queue, remote queue definition and a sender and receiver channel.
However, how do I send a subscription to the remote server ?
I have tried the above and I have tried rfhutilc, but I can not get it to work. |
|
| Back to top |
|
 |
| Vitor |
| Posted: Thu Nov 13, 2008 3:53 am Post subject: Re: How to setup subscriptions - Remote Linux server |
|
|
Grand High Poobah
Joined: 11 Nov 2005
Posts: 26093
Location: Texas, USA
|
| nickkirk wrote: |
| However, how do I send a subscription to the remote server ? |
Send a properly formatted subscription message to the remote control queue, using the set up you've described.
_________________
Honesty is the best policy.
Insanity is the best defence. |
|
| Back to top |
|
|
| nickkirk |
| Posted: Thu Nov 13, 2008 8:27 am Post subject: |
|
|
Apprentice
Joined: 26 Sep 2008
Posts: 48
|
Solved !
My channel was not communicating correctly. Very annoying !
As described in my initial post, I can send a subscription to the remote server  |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
