MQSeries.net :: View topic

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » MQMD Issue

MQMD Issue

« View previous topic :: View next topic »

Author

Message

scar

Posted: Thu Jul 10, 2008 12:52 pm Post subject: MQMD Issue

Centurion

Joined: 23 Jun 2004
Posts: 145

I am getting the following error when executing a flow

The message received at output node 'ConvertXMLtoTAB.Control(Out)' does not contain a valid MQMD. State = '-1' 'MQW001' '0' ''

The message is put to the broker by MQ Workflow and nothing is changed on the workflow side or on broker...

MB V 6.0.1
AIX v 5.2
MQ v 6.0.2.3

Any help is appreciated..

scar

Posted: Thu Jul 10, 2008 1:54 pm Post subject:

Centurion

Joined: 23 Jun 2004
Posts: 145

I copied the same message to a different environment and its working fine.

None of the environment variables are changed.

sridhsri

Posted: Thu Jul 10, 2008 5:15 pm Post subject:

Master

Joined: 19 Jun 2008
Posts: 297

If possible, can you paste the contents of MQMD just before it reaches MQOuput ?

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » MQMD Issue

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP