| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Cannot resolve input node. |
« View previous topic :: View next topic » |
| Author |
Message
|
| nravi |
 Posted: Fri Jul 13, 2007 3:03 pm Post subject: Cannot resolve input node. |
 |
|
Newbie
Joined: 13 Jul 2007
Posts: 2
|
I am using WMB v6
I have defined a message flow project and message flow that reads a comma separated input (TDS1) over an MQInput node and outputs as CWF1. I have defined a Message set project, message set and message definition file. Separator is ','. The Project flow and the Set Project been associated in the properties with each other.
In the MQInput node, I can see the message set, and the message format (TDS1), but I cannot see the Message type.
If I set it to the value that is set in my message definition, it gives the following message when I try to test my flow.
"The message specified in the input node cannot be resolved. Ensure that message fields is resolvable through the message flow project dependency, re-open the test client and try again." What am I missing ?
If I modify my flow to read XML1 and output as CWF1, it works fine.
Appreciate any help that you can provide. |
|
| Back to top |
|
 |
| jefflowrey |
| Posted: Fri Jul 13, 2007 8:56 pm Post subject: |
|
|
Grand Poobah
Joined: 16 Oct 2002
Posts: 19981
|
Are there any warnings in the Toolkit about the TDS layer on the Message Set project?
Are you on 6.0.2.x of the toolkit?
_________________
I am *not* the model of the modern major general. |
|
| Back to top |
|
|
| nravi |
| Posted: Mon Jul 16, 2007 8:56 am Post subject: |
|
|
Newbie
Joined: 13 Jul 2007
Posts: 2
|
| yes, I have 6.0.2x with all the updates and fixpack 4 applied. |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
