ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » General IBM MQ Support » Channel not starting

Post new topic  Reply to topic
 Channel not starting « View previous topic :: View next topic » 
Author Message
enigma
PostPosted: Tue Jul 05, 2005 8:55 pm    Post subject: Channel not starting Reply with quote

Newbie

Joined: 28 Jun 2005
Posts: 8
Hi
I am trying to start a channel using runmqchl -c CHANNEL1 of type receiver. It is saying that the type of channel not suitable for action requested ( AMQ9502) and channel program ended abnormally (AMQ9999).I am working on AIX. I couldnt figure out wats the problem is . Also why its not suitable to start the channel. If anybody has faced this type of problem, please suggest me wats wrng with it. Any help would be appreciated.

Thx in advance
Back to top
View user's profile Send private message
EddieA
PostPosted: Tue Jul 05, 2005 10:37 pm    Post subject: Reply with quote

Jedi

Joined: 28 Jun 2001
Posts: 2453
Location: Los Angeles
Quote:
of type receiver

Normally, you wouldn't start a receiver channel. You start the corresponding sender, and it kicks the receiver into life.

Cheers,
_________________
Eddie Atherton
IBM Certified Solution Developer - WebSphere Message Broker V6.1
IBM Certified Solution Developer - WebSphere Message Broker V7.0
Back to top
View user's profile Send private message
fjb_saper
PostPosted: Wed Jul 06, 2005 12:51 pm    Post subject: Reply with quote

Grand High Poobah

Joined: 18 Nov 2003
Posts: 20756
Location: LI,NY
Unless the receiver has been specifically stopped.
Then you need to manually start it using runmqsc (or some tool).
Remember in order to have a working connection the listener on the receiver qmgr must be running.

Use runmqsc to check on channel status and to manually start and stop channels.

Enjoy
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » General IBM MQ Support » Channel not starting
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
  
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.