MQSeries.net :: View topic - problems while pointing to full repo qmgr

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » Clustering » problems while pointing to full repo qmgr

problems while pointing to full repo qmgr

« View previous topic :: View next topic »

Author

Message

techno

Posted: Fri Mar 11, 2005 2:32 pm Post subject: problems while pointing to full repo qmgr

Chevalier

Joined: 22 Jan 2003
Posts: 429

I am facing lot of problems while moving a partial repo qmgr from one full-repo-qmgr to another full-repo-qmgr.

While doing so, I still see a clusqmgr to old full-repo-qmgr. I do not see any clusqmgr belonging to new-full-repo-qmgr. Doing refresh, resume and so many others.. I am tired now. what can I do now. Any suggestions???

thanks

sebastianhirt

Posted: Sun Mar 13, 2005 11:59 pm Post subject:

Yatiri

Joined: 07 Jun 2004
Posts: 620
Location: Germany

Sorry, this question might be a bit ignorant, but is there a particular reason why you want to let this partial repos show to another full repos?

For me there is no reason to do so. Assuming the Cluster is set up properly, you could even take the one Full Repos your Partial ReposQM is showing to, out of the cluster without anything bad happening. The Partial Repos QM would then assume another Full Repos QM to be it's main one.

Changing the Cluster Sender channels (and AFAIK restart it) shoult get you fixed, though.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » Clustering » problems while pointing to full repo qmgr

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP