ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » MQ5.1 on NT4.0SVR

Post new topic  Reply to topic
 MQ5.1 on NT4.0SVR « View previous topic :: View next topic » 
Author Message
dashton
PostPosted: Fri Nov 26, 2004 6:24 am    Post subject: MQ5.1 on NT4.0SVR Reply with quote

Newbie

Joined: 26 Nov 2004
Posts: 1
OK edit, i didnt seach the forums properly. Basically got loads os 10054 errors, have checked the network ok then....

I stopped the service and got this service controller error:

The IBM MQSeries service has reported an invalid current state 20.

I killed any remaining amq* processes running and restarted. Everything appears to start OK without error, but a dis ch(*) now produces this error:

2 : dis chs(*)
AMQ8420: Channel Status not found.

Connectivity between hosts appears to be fine and they have confirmed that they;re up. Earlier on the channel was in RETRY until we stopped the service. We're listening, they're listening....

and now I'm stuck...
Anyone got a plan?

Regards
Dave
Back to top
View user's profile Send private message
fjb_saper
PostPosted: Fri Nov 26, 2004 7:47 am    Post subject: Reply with quote

Grand High Poobah

Joined: 18 Nov 2003
Posts: 20756
Location: LI,NY
dashton wrote:
2 : dis chs(*)
AMQ8420: Channel Status not found.

This is a good message and not to be taken as an error.

I assume here that your channels are triggered. The message above just states that the channel is inactive right now. You will only see the Running status while the sender channel is running (for a receiver). After the configured period of inactivity the channel goes to inactive. It will restart automatically when triggered.

Enjoy
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » MQ5.1 on NT4.0SVR
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
  
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.