ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » General Discussion » How do I make MQ Series fault tolerant?

Post new topic  Reply to topic
 How do I make MQ Series fault tolerant? « View previous topic :: View next topic » 
Author Message
RobinS
PostPosted: Thu Feb 12, 2004 6:03 am    Post subject: How do I make MQ Series fault tolerant? Reply with quote

Newbie

Joined: 12 Feb 2004
Posts: 1
Location: Sweden

Hi,

I am new to MQ Series. I have some design questions about the best practise to set up a fault tolerant system with MQ Series.

I have an application that has a primary and a hot standby process. I want to add MQ Series to this application.

I want the MQ Series to be fault tolerant aswell, otherwise I have a singel-point of failure in my system.

Can I setup so from the application point of view there is just one logical queue to connect to and
MQ Series decides what QM is the primary QM? I guess this will be done through clustering, is that correct?

The transmission channels, can I setup 2 pairs that goes over two diffrent net? If the first fails it should try the other
transmission channel, is that possible?

Is there any kind of documentation how to setup this kind of system?

thanks in advance,
Robin
Back to top
View user's profile Send private message
jefflowrey
PostPosted: Thu Feb 12, 2004 6:06 am    Post subject: Reply with quote

Grand Poobah

Joined: 16 Oct 2002
Posts: 19981

Yes, this will be through clustering.

BUT it will not be through MQSeries clustering. You will use your normal hardware clustering system for your platform - MSCS, Veritas, HACMP, and etc.

MQSeries gets configured as a participant service in the hardware/os clustering environment.
_________________
I am *not* the model of the modern major general.
Back to top
View user's profile Send private message
crossland
PostPosted: Fri Feb 13, 2004 3:46 am    Post subject: Reply with quote

Master

Joined: 26 Jun 2001
Posts: 248

What platform are you looking at?

Regards,

Tim Crossland
http://www.solent-consultancy.com
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » General Discussion » How do I make MQ Series fault tolerant?
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
 
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.