ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » General IBM MQ Support » Q: Message Sequence Errors

Post new topic  Reply to topic
 Q: Message Sequence Errors « View previous topic :: View next topic » 
Author Message
mqnewbie2003
PostPosted: Tue Sep 09, 2003 8:33 am    Post subject: Q: Message Sequence Errors Reply with quote

Newbie

Joined: 09 Sep 2003
Posts: 1

Hi there,

Can anyone offer any advice as to the potential cause of recurring message sequence errors across a channel pair.

I have a server/requester channel pair at the local and remote qmgr. Both channels have been stopped, and their message sequence numbers reset. Everything restarts fine, but after a period, the sequence numbers become mismatched again.

Any suggestions on symptoms, or perhaps something in the channel configs?

Thanks in advance.

Peter
Back to top
View user's profile Send private message
skn
PostPosted: Wed Sep 10, 2003 6:19 am    Post subject: Reply with quote

Centurion

Joined: 21 May 2003
Posts: 112
Location: Dallas

One possible reason could be unreliable network connections.In that case theres nothing much you can do except trying to make the network more roboust.
Back to top
View user's profile Send private message
jhalstead
PostPosted: Wed Sep 10, 2003 8:23 am    Post subject: Reply with quote

Master

Joined: 16 Aug 2001
Posts: 258
Location: London

On some older versions of MQ on the less common platforms e.g TPF there can be problems if the taret queue mananger can have different underlying IP addresses.

In one instance we were communicating from AIX to a TPF system whos DNS could resolve to one of 4 IP addresses. The channel sequence number was stored against each IP, so if the connection ever dropped or the channel became inactive on restart it was odds on that we'd connect to a different IP address and hence get a sequence number mismatch and in-doubt situation.

If this is not relevant (probably not!) & network is the suspect then you could look at droping the disconnect interval of the channel, this may well reduce the exposure to the network glitches, however it will lead to increased traffic as the channel will need to reconnect more often.

Good luck

Jamie
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » General IBM MQ Support » Q: Message Sequence Errors
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
 
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.