|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
Mesg Broker Toolkit is unable to communicate with ConfigMgr |
« View previous topic :: View next topic » |
Author |
Message
|
Dhiren |
Posted: Wed Oct 25, 2006 6:39 pm Post subject: ConfigMgr Runnig ?? |
|
|
Novice
Joined: 27 Jan 2005 Posts: 17
|
mangoman,
Are u sure your Configmgr is running ?
You can check ur services. Its pretty trivial but one often forgets to start (cmd : mqsistart ConfigmgrName) after its created.
Cheers !!! |
|
Back to top |
|
 |
mangoMan |
Posted: Thu Oct 26, 2006 8:20 am Post subject: |
|
|
Acolyte
Joined: 16 Oct 2003 Posts: 69
|
I am certain that it is running. I have checked it. |
|
Back to top |
|
 |
mqmatt |
Posted: Wed Nov 01, 2006 6:36 am Post subject: |
|
|
 Grand Master
Joined: 04 Aug 2004 Posts: 1213 Location: Hursley, UK
|
Quote: |
The attempt to allocate a conversation using TCP/IP to host 'IBM-X6A2G3VPRSX (ÌU¥qäU¥q) (1417)' was not successful. However the error may be a transitory one and it may be possible to successfully allocate a TCP/IP conversation later.
Try the connection again later. If the failure persists, record the error values and contact your systems administrator. The return code from TCP/IP is 10061 (X'274D'). The reason for the failure may be that this host cannot reach the destination host. It may also be possible that the listening program at host 'IBM-X6A2G3VPRSX (ÌU¥qäU¥q) (1417)' was not running. If this is the case, perform the relevant operations to start the TCP/IP listening program, and try again. |
This sounds scarily deep inside the TCP/IP stack. Are you having any problems with other networked applications?
Perhaps run this one by your network guys - the ones who set up your domain. If that doesn't work, raise a PMR. |
|
Back to top |
|
 |
accosun |
Posted: Thu Nov 16, 2006 8:34 am Post subject: |
|
|
Apprentice
Joined: 20 Dec 2001 Posts: 45 Location: Moscow
|
Hi!
And how do you run Toolkit? Through Programms menu or from command line?
Try to open Command Console, change dir to Message Broker Toolkit and run wmbt command. May be this helps... |
|
Back to top |
|
 |
JosephGramig |
Posted: Thu Nov 16, 2006 12:08 pm Post subject: |
|
|
 Grand Master
Joined: 09 Feb 2006 Posts: 1244 Location: Gold Coast of Florida, USA
|
Your first posts says you QMGR is listening on port 1415.
Try that port in the Toolkit with localhost. _________________ Joseph
Administrator - IBM WebSphere MQ (WMQ) V6.0, IBM WebSphere Message Broker (WMB) V6.1 & V6.0
Solution Designer - WMQ V6.0
Solution Developer - WMB V6.1 & V6.0, WMQ V5.3 |
|
Back to top |
|
 |
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
|