MQSeries.net :: Search

Search

Search

FAQ

FAQÂ Â

Usergroups

Register :: Log in

Log in to check your private messages

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » Search

Search found 5 matches

Author	Message
Topic: How to get the connection Handle for a channel in BINDING?
stupidmqguy Replies: 15 Views: 11734	Forum: General IBM MQ Support Posted: Fri Dec 31, 2010 1:51 am Subject: How to get the connection Handle for a channel in BINDING?
	1. What maintenance level of WMQ are you at? 2. Have you switched on/off trace (briefly) to capture any information while you try to stop the channel? 3. Is this the only queue manager in the cluste ...
Topic: How to get the connection Handle for a channel in BINDING?
stupidmqguy Replies: 15 Views: 11734	Forum: General IBM MQ Support Posted: Thu Dec 30, 2010 10:47 pm Subject: How to get the connection Handle for a channel in BINDING?
	Check what you have mentioned in the CONNAME in cluster sender and receiver ends. Also check there is no network/DNS issue in your system..in order to resolve the connection across. Try to 'PING' th ...
Topic: How to get the connection Handle for a channel in BINDING?
stupidmqguy Replies: 15 Views: 11734	Forum: General IBM MQ Support Posted: Thu Dec 30, 2010 10:40 pm Subject: How to get the connection Handle for a channel in BINDING?
	...Ya we can also check LUWID... My point being that the OP was stupidmqguy's first post on the site, and while I make no assumptions as to his depth of knowledge.. What the SUBSTATE of the chan ...
Topic: How to get the connection Handle for a channel in BINDING?
stupidmqguy Replies: 15 Views: 11734	Forum: General IBM MQ Support Posted: Thu Dec 30, 2010 10:25 pm Subject: How to get the connection Handle for a channel in BINDING?
	...Ya we can also check LUWID... My point being that the OP was stupidmqguy's first post on the site, and while I make no assumptions as to his depth of knowledge, it may be that your (initially da ...
Topic: How to get the connection Handle for a channel in BINDING?
stupidmqguy Replies: 15 Views: 11734	Forum: General IBM MQ Support Posted: Thu Dec 30, 2010 2:51 am Subject: How to get the connection Handle for a channel in BINDING?
	Hi all, I am using MQV6 on AIX 5.3. I have few cluster sender channels that are in BINDING state. When I try to stop the channle i get the below error : AMQ8101: WebSphere MQ error (7F9) has occu ...

Page 1 of 1

Jump to:

Protected by Anti-Spam ACP

Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.