MQSeries.net :: View topic - Multi instance QM port active on both servers

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » General IBM MQ Support » Multi instance QM port active on both servers

This topic is locked: you cannot edit posts or make replies.

Multi instance QM port active on both servers

« View previous topic :: View next topic »

Author

Message

vinumon

Posted: Wed Nov 23, 2016 8:14 am Post subject: Multi instance QM port active on both servers

Acolyte

Joined: 06 May 2014
Posts: 59

Once qm got fail over the port didnot failover and it was active on both nodes.. due to this application tried connecting to the standby node via load balancer and it got failed to connect..as queuemanager was not available.. this multi instance is set up on SAN storage..also once after application reboot then it as able to connect to active qm

exerk

Posted: Wed Nov 23, 2016 11:40 am Post subject:

Jedi Council

Joined: 02 Nov 2006
Posts: 6339

Locked as part-duplicate of THIS.
_________________
It's puzzling, I don't think I've ever seen anything quite like this before...and it's hard to soar like an eagle when you're surrounded by turkeys.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » General IBM MQ Support » Multi instance QM port active on both servers

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP