| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Cluster connection |
« View previous topic :: View next topic » |
| Author |
Message
|
| peterw686 |
 Posted: Thu May 27, 2004 5:34 am Post subject: Cluster connection |
 |
|
Acolyte
Joined: 26 Sep 2002
Posts: 73
|
Hi All,
We tried to build a cluster. However, it always shows "SYSTEM.TEMPXXXXX" when we displayed the clusqmgr. We checked the channels on both sides and they are matched. We also mannully started channels everytime, still couldn't work.
We just could not figure it out. Needs your help.
Also, we built a same cluster one week ago. It was fine, so I suspect if it's the network issue?
Any advise is appreciated. |
|
| Back to top |
|
 |
| PeterPotkay |
| Posted: Thu May 27, 2004 5:46 am Post subject: |
|
|
Poobah
Joined: 15 May 2001
Posts: 7717
|
|
| Back to top |
|
|
| peterw686 |
| Posted: Thu May 27, 2004 7:08 am Post subject: |
|
|
Acolyte
Joined: 26 Sep 2002
Posts: 73
|
Hi Peter,
I looked that topic before and I checked the connection name as well as port number carefully. No clue. |
|
| Back to top |
|
|
| PeterPotkay |
| Posted: Thu May 27, 2004 7:12 am Post subject: |
|
|
Poobah
Joined: 15 May 2001
Posts: 7717
|
I guess you have to lay out all your definitions for us, including QM names and port #s.
The basic problem is that the channels are not talking fully both ways. This is either because there is a network problem, or a typo in your channel definitions.
For Ha-Has, try making a regular SNDR - RCVR channel both ways between the 2 QMs in question. Get that working first to prove the network is up, and that you are picking the correct DNS names (or IP addresses), port #s etc.
_________________
Peter Potkay
Keep Calm and MQ On |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
