Joined: 05 Sep 2001 Posts: 3779 Location: Torrance, CA, USA
Hi,
I am having problems with DxPool Plug-in. I first copied the supporting files to appropriate directories and then added an entry for the message catalogue to the registry. It seems the entry is not correct.
I am getting following messages after deploying the message flow in Control Center.
*************************************************
BIP2087I: Broker MQSI_BROKER_1 was unable to process the internal configuration message.
The entire internal configuration message failed to be processed successfully.
Use the messages following this message to determine the reasons for the failure.
BIP4041E: Execution group 'default' received an invalid configuration message. See the following messages for details of the error.
The message broker received an invalid configuration message and has not updated its configuration. This can arise as a result of errors in the specification of either message flows or message sets which the configuration manager was unable to detect. It can also result from a message flow requiring a type of node that is not supported by the broker installation, from the broker having become out of step with the configuration database or from other applications sending extraneous messages to the broker's configuration queues (SYSTEM.BROKER.ADMIN.QUEUE and SYSTEM.BROKER.EXECUTIONGROUP.QUEUE).
Check the relevant message flow and message set definitions, check that all necessary plug-ins are installed, perform a complete redeploy of the broker's configuration and ensure that no applications are writing to the broker's configuration queues.
BIP0054E Cannot open message catalog file MQSI-DxPool.
The message catalog file could not be opened.
The text for the message 10 could not be obtained.
Turn on Control Center tracing to capture details of the error.
Retry the operation and contact your IBM support center.
*************************************************
The last message (BIP0054E) says, Unable to open message catalog file. I made sure the path for the dll file (pluginMsg.dll) is correct. Do i have to recomiple the source before using it? I am using MQSI V2.0.2.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum