ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » nofile values not getting reflected in mqconfig command

Post new topic  Reply to topic
 nofile values not getting reflected in mqconfig command « View previous topic :: View next topic » 
Author Message
jithinvijay1990
PostPosted: Wed May 05, 2021 5:12 am    Post subject: nofile values not getting reflected in mqconfig command Reply with quote

Newbie

Joined: 17 Dec 2013
Posts: 7

Hi All,

I installed MQ v 9.0.04 and while running mqconfig few parameters failed (no files. I tried to set the values in /etc/security/limits.conf as below.

mqm soft nofile 10240
mqm hard nofile 10240

But still mqconfig is failing for nofile. I already have a QM running. Is it because of that? Sorry i cant delete QM to check as its work related server.
Thanks in advance.
Back to top
View user's profile Send private message
exerk
PostPosted: Wed May 05, 2021 5:42 am    Post subject: Reply with quote

Jedi Council

Joined: 02 Nov 2006
Posts: 6339

And as which user are you running mqconfig?
_________________
It's puzzling, I don't think I've ever seen anything quite like this before...and it's hard to soar like an eagle when you're surrounded by turkeys.
Back to top
View user's profile Send private message
gbaddeley
PostPosted: Wed May 05, 2021 3:17 pm    Post subject: Reply with quote

Jedi

Joined: 25 Mar 2003
Posts: 2492
Location: Melbourne, Australia

Did you log off and log back on again to mqm? (or su or sudo)
ulimit -a command shows your logon shell limits.
You'll need to restart the qmgr for changes to take effect on the qmgr processes.

BTW, are you experiencing any FDCs or errors related to MQ unable to open files or allocate file descriptors? If not, you are probably in no immediate danger.
_________________
Glenn
Back to top
View user's profile Send private message
jithinvijay1990
PostPosted: Thu May 06, 2021 11:17 pm    Post subject: Reply with quote

Newbie

Joined: 17 Dec 2013
Posts: 7

Well, it was my mistake. I had run it as a different user. When i ran mqconfig as mqm user, i could see all IBM reccommendations as PASS. Thank you all for sparing your time to help me.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » nofile values not getting reflected in mqconfig command
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
 
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.