Second, you might check whether you need an "=" or an "==" or etc.
Third, the structure of your model is very unclear. Perhaps you tried to use spaces to indent and then didn't put it inside a [ c o d e ] block. _________________ chmod -R ugo-wx /
MT543
A
SM20CÂ
SM15BÂ
SM19DÂ
B
SW98A
Q X
D 20
SW98A
Q Y
D 30
C
SW23GÂ
SM89FÂ
DÂ
SW98FÂ
SW64A
Its already existing interface.
If i am sending single segment its working but try for mutiple its not working.see the structure which is working.
Working Structure :
MT543
A
SM20CÂ
SM15BÂ
SM19DÂ
B
SW98A
Q Y
D 30
C
SW23GÂ
SM89FÂ
DÂ
SW98FÂ
SW64A
Again. I can't tell what fields are children of what fields. You must wrap your data in [ c o d e ] blocks if you want to use spaces or other indents.
And again. MRM is bad.
Even if it's working.
Also, you haven't mentioned what version of IIB you are using. If you are using anything lower than v9, you should strongly consider finding another client or job. _________________ chmod -R ugo-wx /
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum