MQSeries.net :: View topic - BIP2051E Unable to create config service having single quote

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » BIP2051E Unable to create config service having single quote

BIP2051E Unable to create config service having single quote

« View previous topic :: View next topic »

Author

Message

ceteareth

Posted: Wed Oct 05, 2016 11:42 pm Post subject: BIP2051E Unable to create config service having single quote

Acolyte

Joined: 12 Aug 2012
Posts: 51

Hi Everyone...I am unable to create configurable service which has a single quote in it. I was able to add the same using MQExplorer but via command prompt I am getting an exception.
I am thinking that there might be an escape character that I should use but I am currently at loss. Hoping someone could help me out.

Code:

C:\Program Files\IBM\MQSI\9.0.0.1>mqsicreateconfigurableservice IB9NODE -c UserDefined -o Test -n test1 -v "ID='123456'"
BIP2051E: Broker IB9NODE (UUID c6d87a63-e023-4ca6-b19e-ced384a07471) could not process an internal configuration message to completion, the problem was caused by 'Create : test1 : ID='.
The configuration message could not be processed and was rejected.
Use the inserts within this message to determine the cause of the problem. Correct the broker's configuration and redeploy using the Integration Toolkit, mqsideploy command or a CMP application. Contact your IBM support center if you are unable to resolve the problem.
BIP2087E: Broker 'IB9NODE' was unable to process the internal configuration message.
The entire internal configuration message failed to be processed successfully.
Use the messages following this message to determine the reasons for the failure. If the problem cannot be resolved after reviewing these messages, contact your IBM Support center. Enabling service trace may help determine the cause of the failure.

BIP8036E: Negative response received.
This command sends an internal configuration message to the broker, the response received indicated that the internal configuration message was unsuccessful.
Check that the WebSphere MQ transport is available. Check the system log for further information.

C:\Program Files\IBM\MQSI\9.0.0.1>

Craig B

Posted: Thu Oct 06, 2016 1:45 am Post subject:

Partisan

Joined: 18 Jun 2003
Posts: 316
Location: UK

Your command runs fine on V9.0.0.5 and V10. If your command prompt is accurate that you are running 9.0.0.1 then I would consider upgrading to later maintenance levels.
_________________
Regards
Craig

ceteareth

Posted: Thu Oct 06, 2016 2:44 am Post subject:

Acolyte

Joined: 12 Aug 2012
Posts: 51

I am running 9.0.0.1 on my local, good thing we are using 9.0.0.5 in our dev,test and prd environment. i confirmed that the command is working on 9.0.0.5. Thanks man

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » BIP2051E Unable to create config service having single quote

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP